Honestly it looks like the nozzle could be too hot cause I don’t see any consisten lines

I start at 62(and stay there) that’s the magic number i found for my sovol 6 and 6 plus, at lower I would experience warping and bad bed adhesion. And I’ve had the same correlation with mine at home and the 3 I have at work

I usually have to run mine between 62-65, kinda depends how cold my house is but that’s the same bed I have on my sovols, also get a playing card and make sure you can barely feel the nozzle on the surface of the card. That’s how I do mine

What’s the bed temp at? I usually have to run mine around 62C for PLA and turn the cooling fan to 20% or off.

This is what I was planning, I added a small nvme drive to my desktop to put Linux on

Is dual boot a good way to ease yourself in? I literally just made a new nvme partition to try a dual boot

I do it as a side hustle. Not super busy but like friends wanting something and charging a little for it. Or light repair work, replacement brackets or custom stuff for people

I like the sovol sv06 Plus. I have 3

Dumb. Doesn’t back up “chemtrails” you’re trying to generalize this too much, yes they have conducted tests seemingly to verify how the spread of such weapons could occur. None directly harmful. Chemtrails as a clickbait has a much more sinister connotation. And none of these sources are much more than validation studies

Wikipedia is not a credible source