Convert a CSV into a wmv.

Best time was yesterday. Second best time is now.

Or printer of choice and no partner to tie you down!

Like all the words fit in boxes? Like a pictogram? I’m sure there’s a technical term for it

Could this be adjusted for traditional Chinese as well? Or Korean? Seeing as how they are also kind of ‘blocky’ languages?

I would think that comes with experience. Each to their own I suppose. If it makes the technology more accessible, I’m all for it, but not at the cost of increased prices.

I already get a warning for the first part - printer already known what I’ve loaded because I’ve told it. It knows what is currently loaded and can compare against gcode. Of course I could’ve made the mistake of telling it the wrong material when I loaded it, and that’s on me.

Alot of poka-yoke stuff then?

Sounds like an application for print farms.

What’s the problem that spool tags solve?

I’m not knocking against this initiative by prusa, but the idea of spool tags in general.

FreeCad is actually very decent.

Yup. Try drawing a diagram and arrows with lines beginning and ending exactly where you want it intuitively with your finger. Not too mention you don’t need to unlock your phone, navigate to an app to do it. Just pop out your pen and go. No need to keep anyone waiting if you’re in the middle of discussing something.

Also one of the reasons I was looking to get a fold because the screen real estate was lacking. But they took away pen support in 7 so what the heck.

Taking impromptu notes is what I use it exclusively for. Also to draw quick diagrams and such. The diagrams drawing helps especially.

Just word note taking can be done with any old notes app. But sketches and diagrams. That’s where I use it most.

So the wait continues

If someone comes up with full colour reflected e-ink with refresh rate better than 24 fps, absolutely.

I will jump immediately no second thoughts once any open phone comes with a good stylus.

We should just feed in one tape strip to receive the hole punches after we put in all relevant inputs to perform calculations.

Loads mario, lots of arrows

Tape roll: o

Fuck

I looked quite heavily into the swapper3d, but there doesn’t seem to be much development or adoption there.

Then it’s a leveling issue. That corner is either too high or too low. Not sure why it’s not been suggested yet.

Could you point me to one that overwrites my old posts?