I really don’t know whats happening. Especially with the Over and Underextruding… Heck the Bottom Left pic shows both happening basically right next to eachother… whats going on?

(The Printed Model in the pic is just the Entire First layer and buildplate printed in. Letting it Run a Third time now to see if the Patterns stay the same)

  • The Pantser@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    21 days ago

    That is a bed leveling issue. It’s too far away where there are gaps and too close where there is rippling. Run a bed leveling procedure and if the model allows for manual leveling you should go through that and then do another mesh leveling.

    Also clean your build plate with soap and water and avoid touching it with bare hands.

  • dual_sport_dork 🐧🗡️@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    21 days ago

    Left field suggestion, also: Make sure there isn’t anything trapped under your build plate. If you have any shreds of filament or flakes of old supports or whatever between the steel plate and its magnetic base, the surface won’t be flat to a degree that the auto leveling probably won’t be able to deal with it and you’ll get all kinds of crazy unpredictable results.

    I did this on my Qidi once. I’m glad I noticed before going crazy with troubleshooting. I had black filament scraps on the black magnetic base, which were practically invisible and I only found them by feel.